Hi adboc, yes, now I successful create the two .bin files by the execution of the batch file. I took a HMI SK-S7G2 example file and, as described in the notes,: - I added the pre-build command (AddSectionAttribute.py) in the project property (the .py script that add the "__attribute__ ((section(".qspi_flash")))" to the resources) - I replaced the S7G2.ld file from the bootloader example with the original one present in my project (this step should addresses correctly the application) - I run the batch file and copy the two generated .bin on a USB stick The bootloader on the S7 seems to perform the updating (the onboard LEDs should blink as expected), but at the end , when I reset the board, I cannot see anything on the LCD! Perhaps are there any other steps ore configurations to do to the original project? In order to place the GUIX resources onto the QSPI, is sufficient to perform the first step described above?
↧