Hello Karol I am bit more confused with all these changes even though I can understand partly. My reason for confusion here is as follow a. I created project SSP1.2.0 using Hello World GUIX document provided by Renesas tech support team (synergy_basic_gui_lab_SK_v120.pdf). b. According to document few files were not provided like lcd_setup.c and my_gui_thread.c which initialize LCD panel to display UI components. These two files attached here as well. c. Since these code provided by Renesas team and code what you have provided looks same in logic in my understanding but different variable/instance name. d. Attached configuration panel so you can see some of more details. e. "pins 1_15, 6_10 and 6_11, all as GPIO output (preferably initial-high)." already configured. f. clock phase and polarity already changed to "Data sampling on even edge, data variation on odd edge" This zip file contains lcd_Setup.c, h and my_gui_thread source code, all of these provided by tech support team. (Please visit the site to view this file) Regarding WiFi GT202 on PMODA and Display, reason I wanted to this ways because I have connected AMS sensor on PMOD and got all sensor values to display on my learning project. Now I wanted to send these sensor value to cloud (Renesas IoT) so I can learn device to cloud sequence. There is sample project prebuilt application came with s7g2 starter kit "SmartWine" according to that lab experiment document GT202 connected on PMODA and AMS sensor on PMODB. If I have to swap these boards from one to another what changes I need to make to connect AMS sensor to PMOD A. Already WiFi Application demo (thermostat) working fine with LCD and GT202 on PMODB. Thanks in advance for your valuable guidance. Mariya
↧