yes I have two independent DHCP/IP/pool packet and also independent thread. I am using NetxDuo framework both case. Here additional update If I disable WiFi thread auto start, Ethernet getting resolved. Once Ethernet resolved, I resume Wi-Fi thread on code and Wifi also getting IP address. i.e. both thread running an trying to get IP's its problem. Also instead of auto start disable I added code in wifi thread to wait for Ethernet to resolve then also works. So this leads to think something getting shared which is causing problem if both thread try run simultaneously. Another problem is, if WiFi GT202 is removed from board(LAN is connected) then whole application does not work i.e. on LCD panel is blank. Is that once WiFi is configured for a application GT202 must be present always to run the application ? I have seen similar problem with some of the sample project as well (but stated that it will check WiFi then only work). I wanted to choose between LAN/Wi-Fi interface based on availability. If both present and active then go for Ethernet, otherwise which ever is active use that. Here is my configuration screenshot Thanks
↧