Hi Karol: This is what I did: 1) Select the available board that is closest to your new custom board - this would be the s7g2. (DONE) 2) Make a copy of the existing pin configuration file and rename it to a custom name: MyCustomBoard.pincfg (DONE) 3) Uncheck 'Generate data' for the currently active .pincfg file (DONE, unchecked) Check the 'Generate Data' box under the custom pin configuration file. (DONE, checked) 4) Customize your BSP, Clock and Pin settings on the respective tabs (DONE, and took a while) 5) Click GENERATE PROJECT CONTENT and then SAVE ALL (DONE) 6) Edit board folder name 'synergy/board/ ' to reflect the name of your custom board. Modification to notes should direct people to use lower case characters only: 'synergy/board/custom_user_board' (DONE). Note the s7g2_dk that was regenerated automatically. Where is this coming from???? I will delete this prior to build. 7) Edit file 'synergy_cfg/ssp_cfg/bsp/bsp_board_cfg.h' to replace the board path that follows: Line 4: #include "../../../synergy/board /bsp.h" (DONE) 8) Click Save All (DONE) 9) Right Click on bsp_board_cfg.h, under properties select read only. This creates a warning when compiling. (DONE) 10) Build project (DONE) Even though I deleted s7g2_dk prior to the build, it regenerates and hence the errors above:
↧